The paper presents the results of the experimental tests of Mg/Al bimetallic bars rolling process in classic and multi-radial modified round-oval-round passes. The bimetallic bar consist of magnesium core, grade AZ31 and aluminium outer layer, grade 1050A. The stocks were round bars with diameter 22.5 mm with an aluminium layer share of 28%. As a result of rolling in four passes, bars of a diameter of about 17 mm were obtained. A bimetallic feedstock was manufactured using an explosive welding method. The use of the designed arrangement of multi-radial modified stretching passes resulted in obtaining Mg/Al bimetallic bars with an uniform distribution of the cladding layer over the bar perimeter and high quality of shear strength between individual layers compared to Mg/Al bars obtained in the classic passes.
Boron nitride thin layers were produced by means of the pulsed laser deposition technique from hexagonal boron nitride target. Two types of laser i.e. Nd:YAG with Q-switch as well as KrF coupled with RF generator were used. Influence of deposition parameters on surface morphology, phase composition as well as mechanical properties is discussed. Results obtained using Fourier Transformed Infrared Spectroscopy, Transmission and Scanning Electron Microscopy, Atomic Force Microscopy are presented. Micromechanical properties measured during microindentation, scratch and wear tests are also shown.